Adjustable Fade

Peter 26Nov12: created this page as draft documentation for Adjustable Fade as preparation in case this new fade gets released in 2.0.3.

Use Adjustable Fade... to amplify the audio by a varying amount. This effect is a more advanced and versatile than Fade In and Fade Out in that it is not restricted to fading between silence and the original level but may fade from any amplification amount to any other. The "shape" of the fade can be selected to be linear or non-linear.
As with other Nyquist effects the settings will be "remembered" for the duration of the Audacity session but will revert to their default values when Audacity exits, so you may want to take note of any particularly useful fader curves that you create.

Accessed by: Effect > Adjustable Fade...

Peter 26Nov12: ToDo image will need to be replaced by the release version.

Fade Type

There are just two basic fade types available from this drop-down: Linear and S-Curve; both are selectable as a fade-up or fade-down (fade-in or fade-out). The two "types" have been carefully selected to provide the most useful fade types.

Peter 26Nov12: Further curve types may be added later - TBD.

Mid-fade Cut/Boost

The enables you to modify modifies the initial fade type - to vary the amount of curvature.

Start/End as

This drop-down enables you to choose between percentage or dB as the units to be used in the Start and End gain parameter boxes below.

The obvious, most common / "standard", way to describe the gain levels is as "dB", however there were persistent arguments for using "% of original level", so this option has been included and set as the default.

Start (or end)

Enables you to set the Start (or end) signal level. If you are using percentage units a start value of 0, the default, will give you the start of a fade-in (-96 if you are suing dB units)

End (or start)

Enables you to set the End (or start) signal level. If you are using percentage units a start value of 100, the default, will give you the start of a fade-out (0 if you are suing dB units).

This effect is much easier to use in practice than it is to describe in words so do not be put off by the seeming-complexity of the controls that are available. A few minutes playing with various parameter settings will show you the various resultant fade curve shapes that you can create (a short generated sine wave is useful for this purpose).